You are not logged in.
As of 2 hours ago when I turned on my main PC and wanted to print a pdf file, the job stalls with Rendering completed.
24 hours ago everything was fine. HPLIP really was next-to-perfect. :-)
So far I have tried (not in the order as listed) the following:
Removing the printer
(Re-)Installing the printer via hp-setup -u or hp-setup -i
Only installing the printer via the ppd file from /usr/share/ppd/HP/
Even booted into Win 10 and updated the printer's firmware (and then lost nearly 30 minutes of my life because of these spinning white dots)
All that with reboots in between.
Does anyone have any clue what else I could do?
SOLUTION
Downgrading hplip from 3.18.7-1 to 3.18.6-1 solved the problem!
Last edited by jones (2018-08-08 17:43:17)
Offline
Aw man, there goes my evening and it was relatively simple after all. :-(
A simple downgrade of hplip solved it (for now). Found creatid's reply from 3 years ago on a hunch in regards to search terms and downgraded hplip and then tried printing again... and it goes through perfectly.
SOLVED.
https://wiki.archlinux.org/index.php/Do … g_packages
Last edited by jones (2018-08-07 20:42:55)
Offline