You are not logged in.
I've been trying to figure this out for a while now. I have 2 NICs in my computer on 2 separate networks, one setup as a normal interface and one as a bridge for my VMs, and both connections are working. However, when I connect to an internet service, I am using the IPv4 address from NIC1, and the IPv6 address from NIC2. My goal is to have the computer use the IPv4 and IPv6 addresses from NIC1. I did set the profile to 0 for NIC1 and 10 for NIC2, and no change. I even tried removing the default route for IPv6 from NIC2 using IP and that still didn't work. Does anyone have a (hopefully) quick solution to this?
Offline