Arch Linux

Wu

Member

Registered: 2009-12-27

Posts: 82

ssh server config

Hi,

I'd like to connect from an Arch client to an Arch server via ssh. I just installed Arch on the server and then installed ssh. The ssh daemon service status in the server looks fine:

Started OpenSSH Daemon.
Server listening on 0.0.0.0 port 22.
Server listening on :: port 22.

However, when I launch ssh from the Arch client nothing happens: the terminal cursor just blinks indefinitely.

I normally use the same Arch client to connect to other servers via SSH.

Where should I look for something wrong in the Arch server?

Last edited by Wu (2019-07-24 17:23:35)

Trilby

Inspector Parrot

Registered: 2011-11-29

Posts: 30,530

Website

Re: ssh server config

Add the '-v' flag to your ssh command and post the full command and output here.

---

"UNIX is simple and coherent" - Dennis Ritchie; "GNU's Not Unix" - Richard Stallman

jasonwryan

Anarchist

From: .nz

Registered: 2009-05-09

Posts: 30,426

Website

Re: ssh server config

Moving to NC...

---

Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

tehbrozor

Member

Registered: 2019-07-25

Posts: 3

Re: ssh server config

DId you allow SSH traffic to come in through the server's firewall?! Maybe your packet filter is on and closed up?! Best of luck!