You are not logged in.
Hello good people of the Archlinux forum!
I'm right now trying to install the Archlinux on my CPU to stop using Windows for a long time because of university.
After I did all the necessary to install it and finish with exiting the root and doing reboot, when I do:
[root@scx ~]# systemctl enable dhcpcd@ens18
[root@scx ~]# systemctl start dhcpcd@ens18
It stay like this for 2 minutes and then:
A dependency job for dhcpcd@ens18.service failed. See ' journalctl -xe ' for details
I came back and mounted it again and accessed the root with arch-chroot and tried some things that I even saw here on the forum but nothing sens to work.
The last thing I did was something that made the enp3s0 appears when I do "ip link show dev enp3s0" started to appears just as when I'm at the installation and made the command to "up" the enp3s0.
By now I have no more idea what it could be, if anyone have tips and if I can provide any kinda of information about anything, I'll be here.
Last edited by Schubertyi (2020-02-14 16:01:14)
Offline
What does the journal say about the failed service? Also, I doubt your interface is acutally called ens18.
Moving to NC...
Offline
When the error happens it shows:
scx kernel : sd 6:0:0:0: [sdd] Write Protect is off
scx kernel : sd 6:0:0:0: [sdd] Mode Sense: 03 41 00 00
scx kernel : sd 6:0:0:0: [sdd] No Caching mode page found
scx kernel : sd 6:0:0:0: [sdd] Assuming drive cache: write through
sdd: sdd1
scx kernel : sd 6:0:0:0: [sdd] Attached SCSI removable disk
scx systemd[1] : sys-subsystem-net-devices-ens18.device: Job sys-subsystem-net-devices-ens18.device/start timed out.
scx systemd[1] : Timed out waiting for device /sys/subsystem/net/devices/ens18.
scx systemd[1] : dhcpcd@ens18.service: Job dhcpcd@ens18.service/start failed with result 'dependency'.
scx systemd[1] : sys-subsystem-net-devices-ens18.device: Job sys-subsystem-net-devices-ens18.device/start failed with result 'timeout' .
Offline
What is the output of `ip a` and `systemctl status dhcpcd@ens18.service`?
Offline
Respectively, both commands on the image and the output:
Offline
' ip a' says your ethernet interface is enp3s0 -- I'm not sure why you think it is ens18.
Offline
So I should run "systemctl enable dhcpcd@enp3s0"?
Offline
So I should run "systemctl enable dhcpcd@enp3s0"?
You should read the wiki, and not expect to have your hand held here.
Offline
Ok, thank you then. Problem has been solved.
Last edited by Schubertyi (2020-02-14 16:02:16)
Offline