Arch Linux

KeyPercentage9

Member

Registered: 2019-03-24

Posts: 13

systemd-networkd keeps printing 'Configured' every 3 seconds

I configured a static ip address as below:

    zadesk% cat /etc/systemd/network/wired.network
    [Match]
    Name=en*

    [Network]
    Address=192.168.0.5/24
    Gateway=192.168.0.1
    zadesk%

Network works fine. Able to connect to internet. But I see 'Configured' printed in journal every 3 seconds. Not sure what is going on..

    zadesk% journalctl -u systemd-networkd -f
    -- Logs begin at Mon 2019-09-02 09:21:33 EDT. --
    Oct 13 06:21:45 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:21:49 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:21:52 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:21:55 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:21:58 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:01 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:04 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:07 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:10 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:13 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:16 zadesk systemd-networkd[1088791]: enp3s0: Configured
    Oct 13 06:22:19 zadesk systemd-networkd[1088791]: enp3s0: Configured

loqs

Member

Registered: 2014-03-06

Posts: 19,099

Re: systemd-networkd keeps printing 'Configured' every 3 seconds

https://github.com/systemd/systemd/issues/13595

Please use code tags for commands and their output.
Edit:
https://github.com/systemd/systemd-stab … 6637396b46 was added to systemd-stable two days after the last arch upstream sync.
You could flag the package out of date.

Last edited by loqs (2019-10-13 10:38:34)

KeyPercentage9

Member

Registered: 2019-03-24

Posts: 13

Re: systemd-networkd keeps printing 'Configured' every 3 seconds

Thank you. I assume the change has not made into a release. Will use code tags next time.