Arch Linux

Anonymous2020

Member

Registered: 2020-03-03

Posts: 18

"Temporary failure in name resolution" during installation

At the beginning of the installation I run

ip link

that gives

 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: wlan0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue state DOWN mode DEFAULT group default qlen 1000
    link/ether d8:f2:ca:e8:6a:07 brd ff:ff:ff:ff:ff:ff

than

 ping archlinux.org 

gives

 ping: archlinux.org: Temporary failure in name resolution 

So I run

 wifi-menu 

and choose my wifi, enter name and wpa key. Than the output of the

 ping -c 10 archlinux.org 

says that 0% packet loss which is good as far as I understand.
Than at the point where I should download and install all the packages I run

 pacstrap /mnt base base-devel linux linux-firmware vim intel-ucode 

installation begins but after some time it gives an output like (with multiple error messages)

error: failed retrieving file 'package name' from 'server name': Could not resolve host 'server name' 
warning: failed to retrieve some files
error: failed to commit transaction (invalid url for server)
Errors occurred, no packages were upgraded.
==> ERROR: Failed to install packages to new root

After this I tried again

 ping archlinux.org 

and it gives

 ping: archlinux.org: Temporary failure in name resolution 

so it is like I am disconnected but after running

 ip link 

I get

 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00

So I don't see wlan0 anymore. What might be the reason of this?
(a few things that are probably worth mention: 1. I am new to linux and 2.  I had problems on this laptop with wifi previously (I had Ubuntu and occasionally wifi disappears and it stated "Wifi adapter not found" though after reboot it was there again).

shaoyu0209

Member

From: Taiwan

Registered: 2016-10-28

Posts: 42

Re: "Temporary failure in name resolution" during installation

Welcome to Arch!
Is this just a DNS issue? Can you ping an ip like 8.8.8.8 ?

Anonymous2020

Member

Registered: 2020-03-03

Posts: 18

Re: "Temporary failure in name resolution" during installation

ping 8.8.8.8

gives

ping: connect: Network is unreachable

It seems like i can't connect to my wifi. And in router settings I also don't see my laptop being connected(though it was for some time after I've connected via wifi-menu).

Zod

Member

From: Hoosiertucky

Registered: 2019-03-10

Posts: 629

Re: "Temporary failure in name resolution" during installation

Judging from what you've posted , I'm guessing you need to manipulate some DHCP client after you connect with wifi-menu.

hoomanist

Member

From: universe

Registered: 2020-03-08

Posts: 16

Re: "Temporary failure in name resolution" during installation

are you connected to internet?
try wifi-menu
if it doesn't work run rfkill unblock all before run again the above command

---

If you don't want chains on you hand and foot, your only escape is to switch to a free operating system
--richard stallman the great

Anonymous2020

Member

Registered: 2020-03-03

Posts: 18

Re: "Temporary failure in name resolution" during installation

Thanks for your answers. A small update on my issue. I have started over the whole installation and now ip link gives the following

 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DEFAULT group default qlen 1000
    link/ether d8:f2:ca:e8:6a:07 brd ff:ff:ff:ff:ff:ff

As you can see it says BROADCAST and state UP. and ping archlinux.org was with 0 losses. So I have proceeded with installation.

pacstrap /mnt base base-devel linux linux-firmware vim man-db man-pages intel-ucode

works fine this time but during boot loader installation (systemd-boot) when I was making boot loader file i.e. esp/loader/entries/arch.conf (using vim) there appeared a long message with a lot of lines like

[ 4407.061637] iwlwifi 0000:00:14.3: Firmware error during reconfiguration - reprobe!

and many other similar messages from which I understand only that something is wrong with iwlwifi driver. But I ignored this message and finished the installation. And after reboot I get this

[ 2.999180] iwlwifi 0000:00:14.3: Firmware not running - cannot dump error
[ 3.005693] iwlwifi 0000:00:14.3: Failed to run INIT ucode: -5

I can log in using password and it looks like arch is installed but I don't have the connection.
It seems like I am losing wireless connection after some time and I don't know why.

are you connected to internet?
try wifi-menu

wifi-menu does work and I am connected for some time but than it disappears.

I'm guessing you need to manipulate some DHCP client after you connect with wifi-menu.

Sorry, but can you be more specific please?