Arch Linux

bositguy

Member

From: Boston, MA

Registered: 2018-04-14

Posts: 2

rcraid on X570

So I finally managed to get the on-board RAID controller to configure my 2 8TB Seagates in a RAID 1 but despite the DKMS module being loaded/installed it doesn't seem that Arch is recognizing the array properly, as it's currently just showing /dev/sd[ab] each with a 1.3TiB partition (when I know it's using the whole disk). Anyone happen to have any ideas what I'm either doing wrong/have misconfigured/etc?