You are not logged in.

#1 2006-09-18 12:55:32

mdv
Member
From: Poland
Registered: 2005-04-09
Posts: 145

pxe install how-to needed

I have two laptops, one is HP nx9000 (archlinux), and the second is Toshiba portege 2000 (no system). What I need to do is to install archlinux on Toshiba via netboot instal (pxe install). I cannot figure out how to configure my HP running arch to allow my toshiba netboot. Is it possible to use computer-computer lan cable, or do I need a router? I have no router so it would be most convenient to use crossed lan cable to connect two computers and then install arch on toshiba.

Any suggestions how can I do this?

Offline

#2 2006-09-18 15:08:01

Lone_Wolf
Administrator
From: Netherlands, Europe
Registered: 2005-10-04
Posts: 12,991

Re: pxe install how-to needed

You will have to configure your HP to function as a BOOTP/DHCP and TFTP server.

This post from the creator of minimax might be helpful : http://minimax.berlios.de/forum/viewtopic.php?t=20


Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.

clean chroot building not flexible enough ?
Try clean chroot manager by graysky

Offline

#3 2006-09-18 20:59:52

mdv
Member
From: Poland
Registered: 2005-04-09
Posts: 145

Re: pxe install how-to needed

I managed to boot with mkpxelinux generated file but I get kernel panic "Cannot fint kinit" or somenthin. Do I need to use minimax, maybe there's some archlinux netboot installation image?

Offline

#4 2006-09-20 21:32:35

Lone_Wolf
Administrator
From: Netherlands, Europe
Registered: 2005-10-04
Posts: 12,991

Re: pxe install how-to needed

Currently there is no netboot image for Arch, but i've done some reading and it looks like all you need is a kernel and a filesystem.

You could try taking the kernel and initrd from tpowa's new ftp-iso .
New ISOs for i686

In the tftp file dir you need to copy the vmlinuz and initrd.img files .
(in the iso they are located here: ISO9660/isolinux )

in the pxelinux.cfg folder there should be a default file .

here's an example i found on this page
General PXE install server

Example of default

--snip--
default linux
prompt 1
timeout 1200
display message.txt
label linux
kernel kernels/bare.i/bzImage
append initrd=initrd.img load_ramdisk=1 prompt_ramdisk=0 ramdisk_size=102400 rw root=/dev/ram
--snip--

If you succeed in doing a pxe install , don't forget to update the wiki.


Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.

clean chroot building not flexible enough ?
Try clean chroot manager by graysky

Offline

#5 2006-09-22 19:07:48

Lone_Wolf
Administrator
From: Netherlands, Europe
Registered: 2005-10-04
Posts: 12,991

Re: pxe install how-to needed

I just checked the archboot and mkbootcd packages Tpowa used for his new boot iso's , and in archboot there is a reference to making a pxelinux boot for archlinux.
I suggest you contact tpowa , he might be able to help you.


Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.

clean chroot building not flexible enough ?
Try clean chroot manager by graysky

Offline

Board footer

Powered by FluxBB