You are not logged in.

#1 2021-07-21 04:47:20

Blyatmobilebr
Member
Registered: 2021-07-21
Posts: 9

[SOLVED] Created partition with no filesystem

Hi everyone,

I was installing the distro according to the wiki and everything was going well until I had to create the partitions with fdisk, to be honest I didn't know much about what I was doing and ended up stuck in the grub mode.
I used "ls" to see all the files available but none of them has a filesystem. What should I do?

Last edited by Blyatmobilebr (2021-07-22 23:40:11)

Offline

#2 2021-07-21 05:02:16

kermit63
Member
Registered: 2018-07-04
Posts: 171

Re: [SOLVED] Created partition with no filesystem

Offline

#3 2021-07-21 05:02:51

jasonwryan
Anarchist
From: .nz
Registered: 2009-05-09
Posts: 30,424
Website

Re: [SOLVED] Created partition with no filesystem

Redo the installation and complete these steps: https://wiki.archlinux.org/title/Instal … partitions


Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

Offline

#4 2021-07-21 05:04:51

Blyatmobilebr
Member
Registered: 2021-07-21
Posts: 9

Re: [SOLVED] Created partition with no filesystem

jasonwryan wrote:

Redo the installation and complete these steps: https://wiki.archlinux.org/title/Instal … partitions

How would do that, if I may? Everytime I turn my notebook on, I get stuck in the grub rescue mode.

Offline

#5 2021-07-21 05:15:58

jasonwryan
Anarchist
From: .nz
Registered: 2009-05-09
Posts: 30,424
Website

Re: [SOLVED] Created partition with no filesystem

Same way you installed in the first place: boot from the live media.


Arch + dwm   •   Mercurial repos  •   Surfraw

Registered Linux User #482438

Offline

#6 2021-07-21 09:56:23

alicavus
Member
From: $HOME, /home/$USER
Registered: 2020-12-01
Posts: 6

Re: [SOLVED] Created partition with no filesystem

Strange... You have managed to install GRUB bootloader, so You already formated the disk, created filesystems, mounted them under /mnt, run arch-chroot and succeeded to install the bootloader. I think it's fine, you just forget/missed out creating the GRUB configuration file by runing

grub-mkconfig -o /boot/grub/grub.cfg

ls command (without any argument) in GRUB "basic shell" will output all current disks and partitions, so there is no file shown. But if you run

ls /

there will be list of files where is grub installed.

If you succeeded to

pacstrap /mnt

during the installation, you can resume installation process, there is no need to start from the point zero. Just boot from instalation media, mount the filesystems  under /mnt and chroot in:

arch-chroot /mnt 

and do whatever  you do, create the grub.cfg, install some stuff etc.

Offline

Board footer

Powered by FluxBB