Arch Linux

FPSUsername

Member

Registered: 2021-09-03

Posts: 17

Easyeffects (pipewire) no audio until I reselect the audio sources

Hello,

Since about a week ago, I experienced issues where audio would stop working after waking my pc from sleep and right after booting up. Audio doesn't work until I switch the audio sources to the actual in/output and then back to the easyeffects sink and source.
Has anybody else experienced this? I am not sure how to fix this issue.

I use an external audio device over USB (Behringer UMC22) for both my BM-800 microphone and my Sennheiser HD 600 headphones.

V1del

Forum Moderator

Registered: 2012-10-16

Posts: 24,120

Re: Easyeffects (pipewire) no audio until I reselect the audio sources

Probably a logical variation of this bug: https://gitlab.freedesktop.org/pipewire … ssues/1354

FPSUsername

Member

Registered: 2021-09-03

Posts: 17

Re: Easyeffects (pipewire) no audio until I reselect the audio sources

Here's the issue reported on GitHub by someone else. I shared my workaround there.
https://github.com/wwmm/easyeffects/issues/1083