Arch Linux

cb951303

Member

Registered: 2007-03-17

Posts: 92

Intel Ethernet doesn't work

My onboard ethernet -which is an Intel e1000e- doesn't work after a fresh install.

Kernel module is loaded

~ $ lsmod | grep e1000e
e1000e                311296  0

Network interface is not there

~ $ ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: wlp5s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue state UP mode DORMANT group default qlen 1000
    link/ether 78:2b:46:c5:9f:d1 brd ff:ff:ff:ff:ff:ff

Any ideas?

loqs

Member

Registered: 2014-03-06

Posts: 18,911

Re: Intel Ethernet doesn't work

Please post the full output of `dmesg` and `lspci -nnk`

cb951303

Member

Registered: 2007-03-17

Posts: 92

Re: Intel Ethernet doesn't work

I did manage to make it work by installing the e1000e-dkms from AUR.

Khere

Member

From: Italy

Registered: 2020-03-04

Posts: 170

Re: Intel Ethernet doesn't work

I did manage to make it work by installing the e1000e-dkms from AUR.

If you have solved the issue, post the topic as solved by adding [SOLVED] at the start

---

Fan of Giorgio Moroder & Mohammad Ammax enemy

amish

Member

Registered: 2014-05-10

Posts: 513

Re: Intel Ethernet doesn't work

I did manage to make it work by installing the e1000e-dkms from AUR.

While this may have worked. But if you have time then you may want to find and report why DKMS worked but built-in module did not work.