You are not logged in.
Pages: 1
Hello everyone,
I am using laptop with a monitor. I am managing display with arandr. When two display is open,
there is no problem. But when i close eDP, other display is become very very slow and freezing.
Mouse cursor moves very slowly. How do you think I can solve this problem?
xrandr -q
Screen 0: minimum 320 x 200, current 3840 x 1080, maximum 16384 x 16384
eDP connected primary 1920x1080+1920+0 (normal left inverted right x axis y axis) 344mm x 193mm
1920x1080 144.03*+ 60.00
1680x1050 144.03
1280x1024 144.03
1440x900 144.03
1280x800 144.03
1280x720 144.03
1024x768 144.03
800x600 144.03
640x480 144.03
DisplayPort-1-0 disconnected (normal left inverted right x axis y axis)
HDMI-A-1-0 connected 1920x1080+0+0 (normal left inverted right x axis y axis) 598mm x 336mm
1920x1080 60.00*+ 74.97 50.00 59.94
1680x1050 60.00
1600x900 60.00
1280x1024 75.02 60.02
1440x900 60.00
1280x800 60.00
1152x864 75.00
1280x720 60.00 50.00 59.94
1024x768 75.03 60.00
800x600 75.00 60.32
720x576 50.00
720x480 60.00 59.94
640x480 75.00 60.00 59.94
720x400 70.08Last edited by fsyscall (2021-12-03 20:15:57)
Offline
Optimus/prime system?
https://wiki.archlinux.org/title/PRIME#Reverse_PRIME - see the 2nd point in the blue note
Offline
Thanks for your answer, adding 10-gpu.conf fixed the problem.
/etc/X11/xorg.conf.d/10-gpu.conf
Section "Device"
Identifier "AMD"
Driver "amdgpu"
BusID "PCI:3:0:0"
EndSectionOffline
I'm not sure how this would impact the described problems, but if the GPU is late you might occasionally run into a race condition and run on software emulation, https://wiki.archlinux.org/title/Kernel … _KMS_start
Edit: Please always remember to mark resolved threads by editing your initial posts subject - so others will know that there's no task left, but maybe a solution to find.
Thanks.
Last edited by seth (2021-10-01 21:30:01)
Offline
Pages: 1