You are not logged in.
Hello, I'm using Arch Linux for the very first time actually Linux altogether. And after some struggle. I finally manage to activate bluetooth but now I have a new problem.
First of all I installed bluez, bluez-utils and pipewire-pulse.
After that
systemctl enable bluetooth.service
systemctl start bluetooth.service
bluetoothctl
power on
scan on
agent on
pair [mac address]
connect [mac address]And it succesfully connects but after a few seconds sound goes off and then stutters. Later it connects again and same thing happens. What can I do?
Last edited by Bulky_Section (2021-11-09 17:59:27)
Offline
Since your other post casually revealed that you're dual booting, first and foremost make sure to see the 3rd link below.
This sounds like wifi interference and or power saving and both are very prone to be thrown off by concurrently running OS and since you claim a reflux to windows it is more than likely that the HW doesn't get properly reset between boots.
Off topic:
I've seen Jason slapping a lot of users on this forum and none of them has not deserved it.
So look inside, re-read that thread and understand how you created that situation.
I assume you have already understood that picking fights with veterans isn't getting you anywhere.
Offline