You are not logged in.
I have Acer Spin 5 with touch screen and stylus.
In settings in Wacom Tablet I did calibration.
There were 4 points to touch on the screen.
I did this and now it is messed up.
When I touch the center of the screen with the stylus, the cursor appears in the bottom right corner.
I tried to recalibrate the screen but with no success.
Wanted to reset it in dconf but I wasn't able to find the proper setting
Last edited by 860lacov (2022-01-15 21:05:05)
Offline
I was able to achieve that with:
dconf reset -f /org/gnome/dconf reset -f /org/gtk/Not a perfect solution because It cleared every setting in my system.
Offline
I just had the same problem and found the relevant dconf key.
For every tablet there is a directory in ''/org/gnome/desktop/peripherals/tablets/":
dconf list /org/gnome/desktop/peripherals/tablets/You just need to reset the "area" key in the tablet's directory (replace {id} with the tablet's directory name):
dconf reset -f /org/gnome/desktop/peripherals/tablets/{id}/areaOffline
I just had the same problem and found the relevant dconf key.
For every tablet there is a directory in ''/org/gnome/desktop/peripherals/tablets/":
dconf list /org/gnome/desktop/peripherals/tablets/You just need to reset the "area" key in the tablet's directory (replace {id} with the tablet's directory name):
dconf reset -f /org/gnome/desktop/peripherals/tablets/{id}/area
Thanks
Not sure if I will need this in the future but it always good to know
Offline