Arch Linux

RounakDutta

Member

From: West Bengal, India

Registered: 2022-02-11

Posts: 192

Website

[SOLVED] Kde volume sliders are acting weird.

I am using boat airdopes 141 bluetooth earphones. I am facing a weird problem with my volume sliders. If I increase or decrease the level of my volume sliders and then leave it. It automatically changes the level of the volume slider. I switched from i3 to kde recently, I faced no problems with pa-applet but with kde I am facing this issue.  This is the issue I am facing.

EDIT: I am only facing this issue with my Headsets (Airdopes 141). The volume sliders of my microphone and output speakers are working. - https://0x0.st/oExG.mkv

Last edited by RounakDutta (2022-11-14 15:54:59)

V1del

Forum Moderator

Registered: 2012-10-16

Posts: 25,300

Re: [SOLVED] Kde volume sliders are acting weird.

You are basically triggering multiple volume adjustments over a wireless connection that takes a while to get properly propagated to the actual device it should "end up" on the volume you left it at eventually. I doubt you can inherently do much about this, other than not frantically sliding around.

FWIW something you should be able to test is disabling HW volume propagation in wireplumber: Set ["bluez5.enable-hw-volume"] = true https://pipewire.pages.freedesktop.org/ … tooth.html, assuming you are using that.

Last edited by V1del (2022-11-09 12:05:59)