You are not logged in.
Pages: 1
I just did a fresh install, and I am getting an issue where when I load a blender project and put the system under any load, both of my monitors loose signal for ~10 seconds, then gets it back. Everything is fine until I do anything in blender again.
This was fine on my old install, and I am not sure what changed.
Ryzen 9 3900x
AMD RX 590
Offline
Update, this turned from bad to worse. My computer crashed during one of these incidents, and the blender project I was working on got overwritten/corrupted, and now loads the default scene. No auto saves, blend1 file also overwritten.
Data loss is not something I can tolerate, especially when I had no such issues on Windows.
Offline
https://wiki.archlinux.org/title/Ryzen#Troubleshooting
when I had no such issues on Windows
Is there still a windows installation?
Offline
There is, but on a separate drive. The issue happened even before this second install.
Offline
"Separate drive" doesn't matter, see the 3rd link below (next to the ryzen troubleshooting ones, particularly the one about the AMD curve optimiser)
Offline
Pages: 1