You are not logged in.
Pages: 1
Hello,
i am new user of Arch.I want to install Arch64 on 2xWD Raptors,sata raid0 with onboard nvidia raid controller.Can anybody help me out ?
I found this doc,but it wasn't so helpful,it didn't work for me.Thank you in advance.:)
EDIT: Actually,my problem is in grub.conf.I don't know how to setup it.
Offline
I've got a nForce3 mobo that has both nVidia powered and Promise powered SATA RAID ports, but I don't have any SATA drives to test with. Just make sure that nForce SATA is enabled in the SCSI section of the kernel config.
Offline
Ok,i found out a solution for that.Grub installed succesfully.
Now my problem is that after rebooting i have an endless loop of GRUB GRUB GRUB...
At the stage of kernel installation i get a message like this: "mdadm not installed - raid arrays won't work".
I'll try enabling nForce Sata.
Offline
NoD, how did you get this going? This is -exactly- what I wish to do, but haven't found a how-to for. Would you be willing to share your experience?
Offline
Pages: 1