Arch Linux

mk4y3l

Member

Registered: 2023-09-03

Posts: 1

How to install GNOME? (problem)

Hello dear firends and  the entire Arch community.
After struggling for 9 hours today, i managed to install Arch linux, but I'm not satisfed with Hyprland. I want to use the GNOME interface, and i've installed it. However, it still retains some Hyperland settings. How can i completely reset the GNOME interfce to its default state and remove all data, traces, software, config fils (everything) related to Hyperland from my device> So that it's as if Hyperland was never installed on my device.

Best regards...

jl2

Member

From: 47° 18' N 8° 34' E

Registered: 2022-06-01

Posts: 1,388

Re: How to install GNOME? (problem)

Welcome to the boards!

Search your '.config' directory and delete relevant files.
Or you can just delete the whole directory and recreate it, the files in it will be recreated by the programms needing them (note this will almost completely reset your user, e.g. you might have to re-configure some stuff)

Last edited by jl2 (2023-09-04 08:02:11)

---

Why I run Arch? To "BTW I run Arch" the guy one grade younger.
And to let my siblings and cousins laugh at Arsch Linux...

Upload longer text output like this