Arch Linux

RedrcknRbn

Member

Registered: 2023-06-27

Posts: 13

[SOLVED] Blender suddenly stopped working

Solved for now as it just randomly started working again...

Hello!
The last time I used Blender was on September 18th, and now when I try to launch it, it doesn't load. When attempting to launch via Terminal, this is the result:

[redd@archlinux ~]$ blender
Read prefs: "/home/redd/.config/blender/3.6/config/userpref.blend"
Error! Unsupported graphics card or driver.
A graphics card and driver with support for OpenGL 3.3 or higher is required.
The program will now close.

This doesn't make sense, since I'm using an NVidia Geforce GTX 1070, and I was using it fine a couple of weeks ago. Any help?

Last edited by RedrcknRbn (2023-09-29 02:19:03)

Lone_Wolf

Administrator

From: Netherlands, Europe

Registered: 2005-10-04

Posts: 14,339

Re: [SOLVED] Blender suddenly stopped working

Please post the contents of /home/redd/.config/blender/3.6/config/userpref.blend .

---

Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.

clean chroot building not flexible enough ?
Try clean chroot manager by graysky

RedrcknRbn

Member

Registered: 2023-06-27

Posts: 13

Re: [SOLVED] Blender suddenly stopped working

Please post the contents of /home/redd/.config/blender/3.6/config/userpref.blend .

It just randomly started working again??? Solved for now I guess...