Arch Linux

tonymj

Member

Registered: 2023-12-28

Posts: 2

[SOLVED]Problem detecting ssd at boot: link online but 1 devices miscl

I've installed a new SSD (Crucial MX500 1000GB) for my /home partition , I've format it to btrfs, set it on fstab and reboot the system. Everything ok so far.

Then, I copied some data on it (about 30Gb), Initially seemed fine, but suddenly after a couple of minutes after finished, the system froze.

On reboot Arch enters on emergency mode, and dmesg shows: "ata10: link online but 1 devices misclassified, device detection might fail"

this is the output related to ata10:

[    7.743798] ata10: link is slow to respond, please be patient (ready=0)
[   12.447340] ata10: found unknown device (class 0)
[   12.603792] ata10: found unknown device (class 0)
[   12.603814] ata10: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[   12.603820] ata10: link online but 1 devices misclassified, retrying
[   17.957127] ata10: link is slow to respond, please be patient (ready=0)
[   22.660048] ata10: found unknown device (class 0)
[   22.817124] ata10: found unknown device (class 0)
[   22.817146] ata10: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[   22.817152] ata10: link online but 1 devices misclassified, retrying
[   28.170461] ata10: link is slow to respond, please be patient (ready=0)
[   33.157131] ata10: found unknown device (class 0)
[   33.317129] ata10: found unknown device (class 0)
[   33.317151] ata10: SATA link up 6.0 Gbps (SStatus 133 SControl 300)
[   33.317157] ata10: link online but 1 devices misclassified, retrying
[   33.317159] ata10: reset failed (errno=-11), retrying in 25 secs
[   59.340437] ata10: limiting SATA link speed to 3.0 Gbps
[   64.353790] ata10: found unknown device (class 0)
[   64.510448] ata10: found unknown device (class 0)
[   64.510470] ata10: SATA link up 3.0 Gbps (SStatus 123 SControl 320)
[   64.510476] ata10: link online but 1 devices misclassified, device detection might fail

Now, lsblk nor fdisk -l shows nothing, and the disk seems dead. Could I try something to check the health of the drive?

Thanks for your help

Last edited by tonymj (2023-12-29 00:19:18)

tonymj

Member

Registered: 2023-12-28

Posts: 2

Re: [SOLVED]Problem detecting ssd at boot: link online but 1 devices miscl

It seems that I used a defective SATA cable, I changed it for another one and now it works flawlessly.

Last edited by tonymj (2023-12-29 00:19:41)