You are not logged in.
This looks increasingly like the disk is dying.
Can you get the smart data from it when attached to the other system?
Offline
Smart! (pun intended)
I'm running an extended test but it's going to take a few hours. Here's the current results: https://0x0.st/XNF4.txt
Offline
The error "revalidation failed (errno=-5)" has begun to appear a few times, and smartctl has frozen when running another command.
Update: "INQUIRY failed" if I re-run `smartctl -a`. dmesg: http://0x0.st/XNFt.txt
Last edited by 0xlogn (2024-06-01 18:51:59)
Offline
5 Reallocated_Sector_Ct 0x0033 095 095 036 Pre-fail Always - 2288
183 Runtime_Bad_Block 0x0032 099 099 000 Old_age Always - 1
196 Reallocated_Event_Count 0x0032 095 095 000 Old_age Always - 2288You've backups, right?
Offline
Yes, I take it this disk is dead?
Oddly enough smartctl -H showed it as PASSING still.
Offline
https://bbs.archlinux.org/viewtopic.php … 1#p2174971
The re-allocation exceeds the limits by some thousands - either the disk is by tihs time mostly rust or the firmware got fried.
Either way, you cannot expect any kind of reliable behavior from the disk anymore. And apparently it starts to choke after some access.
Don't cry - it will move to a serverfarm upstate and only store the funnies memes and cutest kitten pictures for the rest of time.
And porn, of course.
Offline
I've had some issues understanding how to read SMART results: on reallocated sector ct isn't VALUE 95 and not 2288?
I don't know man, if this thing is that fried maybe it can't even store the memes :sob:
Either way, thank you for helping me figure out if it was the disk specifically. Appreciate it lots!
Offline
The raw value column is the relevant one.
Don't worry, the upstate serverfarm is a special place where data gets handled with infinite throughput and no latency and not bit has ever flipped.
It's the happiest place wher any drive can ever be.
Offline
HDD uninstalled and I'm still seeing the PCI physical layer errors. What could it even be at this point?? Should I be concerned?
Offline
https://bbs.archlinux.org/viewtopic.php … 7#p2174797 ist still a bus error, the operative term is "Correctable" but it means that the signal on the bus is polluted.
Does it help to remove the nvme? Though since you rely on an OOT driver, you might have issues testing this w/ some live distro from a USB key… ![]()
Offline
I don't care for the wireless NIC, I don't even plan on installing the driver. This acts as a server, so it's hardwired.
Offline
And can you/have you tried to simply disable or remove it (in case this has further impact on the nvme)?
Offline
When we still had the HDD installed I had removed both the nvme SSD and the NIC, and it was still there. Could it be the bus at fault?
Offline
The HDD seems the HDD's fault, so that's not a good indicator.
The errors in https://bbs.archlinux.org/viewtopic.php … 7#p2174797 are from the NIC and imply there's too much noise on the bus.
Whether this is because the bus lines are degrading or some device is yelling around there would to be seen.
Since the messages there are all from the wifi NIC I'd disable it and see whether you still get bus errors (In this case likely from the nvme, maybe anything else)
As long as the errors can be corrected, this will cause some slow-down, but isn't critical.
If it's too annoying you can **suppress** (this doesn't fix anything!) them w/ "pci=noaer", https://wiki.archlinux.org/title/Kernel_parameters
Offline