Arch Linux

Shagbag

Member

Registered: 2006-10-25

Posts: 259

Wireless Interfaces [RESOLVED]

I have an Intel PRO Wireless 3945 PCIe card installed.  I also have a Realtek RTL8169 Gigabit ethernet card.  The ethernet card is 'eth0' but the ipw3945 shows up as 'eth2':

[n00b@archlinux ~]$ iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      no wireless extensions.

eth2      IEEE 802.11g  ESSID:"ShagNet"
          Mode:Managed  Frequency:2.457 GHz  Access Point: 00:18:4D:3C:DC:E2
          Bit Rate:54 Mb/s   Tx-Power:15 dBm
          Retry limit:15   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=92/100  Signal level=-41 dBm  Noise level=-42 dBm
          Rx invalid nwid:0  Rx invalid crypt:1  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:9   Missed beacon:0

But what is 'eth1' doing there and why isn't my ipw3945 set as 'eth1'??

fk

Member

From: Germany

Registered: 2006-04-29

Posts: 524

Re: Wireless Interfaces [RESOLVED]

eth1 is the firewire card

---

Have you tried to turn it off and on again?

Shagbag

Member

Registered: 2006-10-25

Posts: 259

Re: Wireless Interfaces [RESOLVED]

Thx.  It had me stumped.  How did you know I had a firewire card?

fk

Member

From: Germany

Registered: 2006-04-29

Posts: 524

Re: Wireless Interfaces [RESOLVED]

You tell us, you have one ethernet and one wireless card, and have three cards in ifconfig named "eth", it must be a firewire card.

---

Have you tried to turn it off and on again?

Shagbag

Member

Registered: 2006-10-25

Posts: 259

Re: Wireless Interfaces [RESOLVED]

OK.  Thx.