Arch Linux

Dexter23

Member

Registered: 2022-02-19

Posts: 29

Enable Enhanced Mode HyperV

Hi everyone

i'm try to enable enhanced mode in hyper-v follow the article on the arch wiki:
https://wiki.archlinux.org/title/Hyper- … ssion_mode

But when i run ./makepkg is starting compile and at some point give me this errors:

Package dependency requirement 'xrdp >= 0.10.80' could not be satisfied.
Package 'xrdp' has version '0.10.0-beta2', required version is '>=0.10.80'

I see other thread with similar problem:
https://bbs.archlinux.org/viewtopic.php?id=281072

But i not figure out how the guys has workaround the problem

Thanks.

Dexter23

Member

Registered: 2022-02-19

Posts: 29

Re: Enable Enhanced Mode HyperV

Hi check hyper-v server settings and enable enhanced mode policy and it works just follow the arch wiki and if you have problem follow this:

https://github.com/k247tEK/archVM-Hyper-V

You can close this thread.
Thanks.

ollixx77

Member

Registered: 2025-11-19

Posts: 1

Re: Enable Enhanced Mode HyperV

Had a fresh install on HyperV with enhanced mode enabled. Still the same error message as Dexter23.

Lone_Wolf

Administrator

From: Netherlands, Europe

Registered: 2005-10-04

Posts: 14,951

Re: Enable Enhanced Mode HyperV

Please start a new thread in AUR Issues, Discussion & PKGBUILD Requests subboard.
(xrdp is in AUR)

Clarify if you did follow https://wiki.archlinux.org/title/Xrdp .

Moderator Note
Closing this old thread.

---

Disliking systemd intensely, but not satisfied with alternatives so focusing on taming systemd.

clean chroot building not flexible enough ?
Try clean chroot manager by graysky