Arch Linux

festgreifaah

Member

Registered: 2006-06-12

Posts: 51

TORCS: Memory access error

Is anybody playing TORCS?

I tried it recently, but when I begin racing, the program crashes a few seconds after race start.

This is the output, of torcs. (Speicherzugriffsfehler=Memory access error)

Visual Properties Report
------------------------
Compatibility mode, properties unknown.
GfParmCheckHandle: parameter "Front Wing/angle" out of bounds: min:0 max:0.20944 val:0.523599 in ("NASCAR RWD" - "drivers/lliaw/car.xml")
GfParmCheckHandle: parameter "Rear Wing/angle" out of bounds: min:0 max:0.314159 val:0.523599 in ("NASCAR RWD" - "drivers/lliaw/car.xml")
GfParmCheckHandle: parameter "Rear Wing/angle" out of bounds: min:0 max:0.349066 val:0.523599 in ("Tita" - "drivers/tita/car.xml")
OpenAL backend info:
  Vendor: OpenAL Community
  Renderer: Software
  Version: 1.1
  Available sources: 1024 or more
  Available buffers: 1024 or more
  Dynamic Sources: requested: 1003, created: 1003
  #static sources: 21
  #dyn sources   : 1003
/opt/torcs/bin/torcs: line 52:  4225 Speicherzugriffsfehler  $LIBDIR/torcs-bin -l $LOCAL_CONF -L $LIBDIR -D $DATADIR $*

dmesg gives the following output

torcs-bin[4225] general protection rip:2af7aa3539fd rsp:7fff00bc6ae0 error:0

I'm running arch64, but I don't know, if it's 64-bit specific. So I posted the problem here.

junglepeanut

Member

From: California

Registered: 2007-01-24

Posts: 145

Website

Re: TORCS: Memory access error

I just installed to check on 32...everything works fine.