You are not logged in.
Pages: 1
I'm running a mythtv box on Arch, on an Asus P5B deluxe wifi motherboard. The system has not been stable, periodically I'll go to use it and while the power light is still on, the system is not accessible. Trying to track down what's going on.
This system uses a JMicron pata controller. This seems to be problematic for some reason. Device 03:00.0 is the JMicron controller, per the lspci output. I'm using the latest BIOS updated for the motherboard. Error.log shows an issue of "resource collisions" and other issues with the JMicron device. Where do I begin to fix this?
After my last boot, here is the tail of error.log
May 4 07:40:16 tvbox PCI: BIOS Bug: MCFG area at e0000000 is not E820-reserved
May 4 07:40:16 tvbox PCI: Not using MMCONFIG.
May 4 07:40:16 tvbox PCI: Cannot allocate resource region 2 of device 0000:03:00.0
May 4 07:40:16 tvbox PCI: Cannot allocate resource region 3 of device 0000:03:00.0
May 4 07:40:16 tvbox PCI: Device 0000:03:00.0 not available because of resource collisions
May 4 07:40:16 tvbox PCI: Device 0000:03:00.0 not available because of resource collisions
May 4 07:40:16 tvbox JMB363: dma_base is invalid
May 4 07:40:16 tvbox JMB363: dma_base is invalid
May 4 07:40:16 tvbox usb 2-1: device not accepting address 2, error -71
May 4 07:40:16 tvbox usb 4-1: device descriptor read/64, error -71
May 4 07:40:19 tvbox ntpd[5724]: bind() fd 21, family 10, port 123, scope 2, addr fe80::218:f3ff:fe00:b587, in6_is_addr_multicast=0 flags=17 fails: Cannot assign requested address
May 4 07:40:19 tvbox ntpd[5724]: unable to create socket on eth0 (5) for fe80::218:f3ff:fe00:b587#123
Found this in dmesg, not sure if it's relevant: (haven't tried pci=routeirq yet)
PCI: Probing PCI hardware (bus 00)
PCI quirk: region 0800-087f claimed by ICH6 ACPI/GPIO/TCO
PCI quirk: region 0480-04bf claimed by ICH6 GPIO
Boot video device is 0000:01:00.0
0000:03:00.0: cannot adjust BAR2 (not I/O)
0000:03:00.0: cannot adjust BAR3 (not I/O)
PCI: Transparent bridge - 0000:00:1e.0
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P2._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P1._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P4._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P8._PRT]
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0.P0P9._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 3 4 5 6 7 10 *11 12 14 15)
ACPI: PCI Interrupt Link [LNKB] (IRQs 3 4 5 6 7 *10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKC] (IRQs 3 4 *5 6 7 10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKD] (IRQs 3 4 5 6 7 10 11 12 14 *15)
ACPI: PCI Interrupt Link [LNKE] (IRQs 3 4 5 6 7 10 11 12 14 15) *0, disabled.
ACPI: PCI Interrupt Link [LNKF] (IRQs 3 4 5 6 7 10 11 12 *14 15)
ACPI: PCI Interrupt Link [LNKG] (IRQs *3 4 5 6 7 10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKH] (IRQs 3 4 5 6 *7 10 11 12 14 15)
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI init
pnp: PnP ACPI: found 14 devices
SCSI subsystem initialized
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq". If it helps, post a report
PCI: Cannot allocate resource region 2 of device 0000:03:00.0
PCI: Cannot allocate resource region 3 of device 0000:03:00.0
Last edited by timm (2007-05-04 13:28:21)
Offline
Pages: 1