You are not logged in.
Pages: 1
Hi,
I have just installed a beryl-kde and the beryl-extras package on arch and everything went fine except beryl always falls back to kwin when I try to change to beryl. I am running kde ;-) and I have the nvidia driver installed correctly as far as I know, I followed both the xorg and nvidia wiki pages. Here is my xorg.conf:
# nvidia-xconfig: X configuration file generated by nvidia-xconfig
# nvidia-xconfig: version 1.0 (buildmeister@builder3) Wed Jun 13 18:39:30 PDT 2007
Section "ServerLayout"
Identifier "Layout0"
Screen 0 "Screen0"
InputDevice "Keyboard0" "CoreKeyboard"
InputDevice "Mouse0" "CorePointer"
EndSection
Section "Files"
RgbPath "/usr/lib/X11/rgb"
EndSection
Section "Module"
Load "dbe"
Load "extmod"
Load "type1"
Load "freetype"
Load "glx"
EndSection
Section "InputDevice"
# generated from default
Identifier "Mouse0"
Driver "mouse"
Option "Protocol" "auto"
Option "Device" "/dev/psaux"
Option "Emulate3Buttons" "no"
Option "ZAxisMapping" "4 5"
EndSection
Section "InputDevice"
# generated from default
Identifier "Keyboard0"
Driver "kbd"
EndSection
Section "Monitor"
Identifier "Monitor0"
VendorName "Unknown"
ModelName "Unknown"
HorizSync 30.0 - 110.0
VertRefresh 50.0 - 150.0
Option "DPMS"
EndSection
Section "Device"
Identifier "Device0"
Driver "nvidia"
VendorName "NVIDIA Corporation"
EndSection
Section "Screen"
Identifier "Screen0"
Device "Device0"
Monitor "Monitor0"
DefaultDepth 24
SubSection "Display"
Depth 24
Modes "1600x1200" "1280x1024" "1024x768" "800x600" "640x480"
EndSubSection
EndSection
I only used the nvidia-config utility to create the xorg.conf, nothing existed before that. I remember having the same problem on my desktop a while back which also has an nvidia card and arch installed, but I managed to fix it, alas I can't remember how I did it but it couldn't have been that difficult if I managed it . Can anyone offer me any advice on how to solve this problem?
Thanks in advance for your time,
Calef13
Offline
Pages: 1