You are not logged in.
I need to install the following wired NIC:
01:00.0 Ethernet controller: Agere Systems|ET-131x PCI-E Ethernet Controller (unknown)
It seems that the "et131x" kernel module is necessary.
The web site bellow gives instructions on how to install the driver from sources:
http://dadams1969.googlepages.com/et131xkernelmodule
Unfortunatly I am unable to do it.
I have also tried to install the module compiled by a member at the following address:
http://www.archlinux.org/~tom/packages/
The module seems to be installed properly. A new folder is created in /lib/modules/
However, I am unable to load it.
# modprobe et131x.ko
FATAL: Module et131x.ko not found
#insmod et131x.ko
insmod: error inserting 'et131x.ko': -1 Invalid module format
Am I doing something wrong?
NB:
The module has been compiled for the 2.6.20 kernel and I am using 2.6.22 (i686)...
Last edited by sylvain77 (2007-09-26 08:23:48)
Offline
Heh... I had competely forgotten that I had done that, so now I feel morally obliged to help you.
I just tried a rebuild against 2.6.22 and it failed, but after a little digging around, I found a patch, and now it builds. I can't tell you if it works or not, as I don't have the hardware.
Get the new package in the same place as before, and let me know how it goes.
It's worth noting that this code is 6 months old at this stage, and the project doesn't seem to be very active. There's one 4-mail thread about it on lkml.org, with no indication that this will ever be merged to mainline.
Offline
Thank you very much.
The package has been successfully installed.
However, I still have a problem:
#depmod -a
#modprobe et131x
FATAL: Error inserting et131x (/lib/modules/2.6.22-ARCH/Kernel/drivers/net/et131x.ko): Invalid module format
Is there an additional step to follow before to attempt to load the module?
Last edited by sylvain77 (2007-09-27 08:09:50)
Offline
As mentioned, I can't test this. I found the patch in the et131x forum on SF - it's not from the project itself, but from another user with similar problems. I'd suggest you go there and see if you can get more answers.
Offline
Thank you for your help.
I am going to take a look at the SF forum.
Last edited by sylvain77 (2007-09-27 14:23:54)
Offline
when i load the module i got ksoftirqd/0 or ksoftirqd/1 consuming 20% CPU.. anyone got the same issue ?
Offline
At least you can load it.
I still have the same error when I try to insert the driver.
Did you have to rebuild the module in order to load it?
Last edited by sylvain77 (2007-09-28 05:07:50)
Offline
i installed tomk's package.. ..and works.. (but with the load issue).. what version of kernel26 do you run?
Offline
anyone knows some patch for 2.6.23?
Offline
For the 2.6.23 kernel, please take a look at this thread:
Offline