You are not logged in.
Pages: 1
Hello, I have a doubt. I have followed this wiki to try getting working http://wiki.archlinux.org/index.php/Webcam_Setup
I connect my SN9C102 webcam to the PC, and I get the following dmesg output:
usb 1-2: new full speed USB device using uhci_hcd and address 3
usb 1-2: configuration #1 chosen from 1 choice
usb 1-2: SN9C10[12] PC Camera Controller detected (vid:pid 0x0C45:0x600D)
usb 1-2: PAS106B image sensor detected
usb 1-2: Initialization succeeded
usb 1-2: V4L2 device registered as /dev/video0
usb 1-2: Optional device control through 'sysfs' interface disabled
and the dmesg that I should get (following the wiki) is this:
sn9c102: V4L2 driver for SN9C10x PC Camera Controllers v1:1.24a
usb 1-1: SN9C10[12] PC Camera Controller detected (vid/pid 0x0C45/0x600D)
usb 1-1: PAS106B image sensor detected
usb 1-1: Initialization succeeded
usb 1-1: V4L2 device registered as /dev/video0
usb 1-1: Optional device control through 'sysfs' interface ready
usbcore: registered new driver sn9c102
And my webcam doesn't work correctly, the shown images are extremely bad quality (I am on the camera group) cause, maybe, the driver is not loaded correctly. Why my sysfs interface is disabled? Maybe is that my problem? How can I activate it?
And if not, how can I make working my webcam?
Greetings
Edit: The problem is kopete
Last edited by Davigetto (2007-10-07 11:03:05)
Only deaths can see the end of battles.
Blog: http://djmartinez.co.cc -> The life of a Computer Engineer
Offline
Pages: 1