You are not logged in.
Pages: 1
Hello,
today, I decided to change from Slackware to AL on my Laptop. Everything is working but skippy....
It terminates with the message:
FATAL: Couldn't look up keysym for 'F11 ', bailing out.
I am using skippy 0.5.0, build based on an PKGBUILD I found here in the forum. The same build works on my desktop pc running AL and I also never had problems using it with Slackware.
Any suggestions? I searched different forums and googled - don't know where to continue
thanks,
Jochen.
Offline
Ok, found the solution...
In my .skippyrc, there was a blank behind the line
keysym = F11
That was the evil... :twisted:
--jochen
Offline
Pages: 1