You are not logged in.

#1 2008-08-04 11:56:38

samfiller
Member
Registered: 2008-08-04
Posts: 2

Using udev to map multiple SD

If you read the wiki it explains very well how to obtain the serial of a device the problem is sd cards do report there serial the serial that you get is that of the sd card reader.

Therefore all SD cards will mount the same!

I compared to outputs with two different SD cards the only different I see is that of the size (if they are different size SD's)
i tried adding it in to my rule ATTR{size}=="2007040"  (my size) but then it would not mount!

ANY IDEAS?

Sam

Offline

#2 2008-08-04 13:32:03

brebs
Member
Registered: 2007-04-03
Posts: 3,742

Re: Using udev to map multiple SD

Is it the size of the card, or the size of the card reader wink

Probably should use ATTRS instead of ATTR.

Offline

#3 2008-08-04 19:25:52

samfiller
Member
Registered: 2008-08-04
Posts: 2

Re: Using udev to map multiple SD

Thank you!
But

There is no output for ATTRS size.

any other ideas?

Offline

Board footer

Powered by FluxBB