You are not logged in.

#1 2008-08-27 20:08:47

Clunis
Member
Registered: 2007-10-20
Posts: 2

Arch on RAID0 nforce4 raid set

Hi to all i followed the seguent link to install my Arch on raid0 and all seems work great...
http://wiki.archlinux.org/index.php/Ins … _Fake-RAID

after reboot i have a flood error same as "attempt to access beyond end of device" i read about this error on the net and i've found the problem but not the solution

it seem to say that error because the partitions are stored on a single disk udev can not read the /dev/mapper/nvidia_* array and then flood my boot with this error.


anyone fixed it?


thank you...

Offline

#2 2008-08-28 04:30:17

loosec
Member
Registered: 2007-03-08
Posts: 134

Re: Arch on RAID0 nforce4 raid set

Sounds like you are trying to access /dev/sda somewhere during your bootprocess. Never seen this error when dealing with /dev/mapper/nv* and have reinstalled several times on a nforce4 board.

Offline

Board footer

Powered by FluxBB