You are not logged in.

#1 2004-09-19 11:06:42

ik0
Member
From: Bulgaria
Registered: 2004-07-23
Posts: 16
Website

Can't mount camera with new udev 0.32 - [Solved]

Today I found that I can't mount my camera (BenQ DC3410, but I don't think it's matters). I used to mount it as /dev/sda1 like normal USB storage device, but now there is not /dev/sda1.

There's no /dev/sda or /dev/usb/* . How to mount it ?!? I don't know is the problem in udev, but there was no problem before I upgrade udev .

Offline

#2 2004-09-19 12:14:51

IceRAM
Member
From: Bucharest, Romania
Registered: 2004-03-04
Posts: 772
Website

Re: Can't mount camera with new udev 0.32 - [Solved]

Run "dmesg" as root and look at what usb-storage "says" there.
You could easily find the device that way.

Offline

#3 2004-09-19 12:27:52

ik0
Member
From: Bulgaria
Registered: 2004-07-23
Posts: 16
Website

Re: Can't mount camera with new udev 0.32 - [Solved]

dmesg shows :

usb 1-1: new full speed USB device using address 7
scsi5 : SCSI emulation for USB Mass Storage devices
  Vendor: DSC       Model:                   Rev:     
  Type:   Direct-Access                      ANSI SCSI revision: 02
SCSI device sda: 32768 512-byte hdwr sectors (17 MB)
sda: assuming Write Enabled
sda: assuming drive cache: write through
 /dev/scsi/host5/bus0/target0/lun0: p1
Attached scsi removable disk sda at scsi5, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi5, channel 0, id 0, lun 0,  type 0
USB Mass Storage device found at 7

but there's no /dev/scsi . Should I mkdev or something ? I'm not sure how to make it. Or to write some udev.rules ?

Offline

#4 2004-09-19 12:30:34

ik0
Member
From: Bulgaria
Registered: 2004-07-23
Posts: 16
Website

Re: Can't mount camera with new udev 0.32 - [Solved]

Solved ! smile

I start /etc/start_udev and everything is OK now smile Thanks anyway !

final question : Is it required to start /etc/start_udev after every update of udev ?

Offline

#5 2004-09-19 12:34:11

IceRAM
Member
From: Bucharest, Romania
Registered: 2004-03-04
Posts: 772
Website

Re: Can't mount camera with new udev 0.32 - [Solved]

Hmm... I don't know, probably
I restart my system when core packages change (such as gcc, udev, kernel, libs*).

Make sure you are actually running your system with UDev (proper kernel params, see UDev wiki).

Offline

Board footer

Powered by FluxBB