You are not logged in.

#1 2008-11-25 23:43:39

juliousdean
Member
Registered: 2007-04-12
Posts: 37

Gigabit ethernet (tg3) problem

Hi all

i have this ethernet

 Ethernet controller: Broadcom Corporation NetLink BCM5789 Gigabit Ethernet PCI Express (rev 21)

using tg3 driver but link is up to a speed of 100 as ethtool shows

Settings for eth0:
    Supported ports: [ TP ]
    Supported link modes:   10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Supports auto-negotiation: Yes
    Advertised link modes:  10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Advertised auto-negotiation: Yes
    Speed: 100Mb/s
    Duplex: Full
    Port: Twisted Pair
    PHYAD: 1
    Transceiver: internal
    Auto-negotiation: on
    Supports Wake-on: g
    Wake-on: d
    Current message level: 0x000000ff (255)
    Link detected: yes

I tried changing speed with ethtool but nothing happens

It is connected to a Gigabit switch wich operates perfectly (other computers on switch work in Gigabit speed)

Any ideas?

Offline

Board footer

Powered by FluxBB