Arch Linux

Roberth

Member

From: The Pale Blue Dot

Registered: 2007-01-12

Posts: 894

Logitech dinovo edge stopped working

Hello, my Logitech dinovo edge wireless keyboard stopped working at one point in the last few days, when I use it, I can't get any response from the computer when I hit any keys or use the touchpad.

It used to work out of the box I just had to run the bluetooth, and it worked.

Here's an output of the log, when connecting the bluetooth dongle to the computer:

Sep 21 10:40:51 Magda usb 1-8: new full speed USB device using ohci_hcd and address 13
Sep 21 10:40:51 Magda usb 1-8: configuration #1 chosen from 1 choice
Sep 21 10:40:51 Magda hub 1-8:1.0: USB hub found
Sep 21 10:40:51 Magda hub 1-8:1.0: 3 ports detected
Sep 21 10:40:52 Magda usb 1-8.2: new full speed USB device using ohci_hcd and address 14
Sep 21 10:40:52 Magda usb 1-8.2: configuration #1 chosen from 1 choice
Sep 21 10:40:52 Magda input: Logitech Logitech BT Mini-Receiver as /class/input/input12
Sep 21 10:40:52 Magda input,hidraw5: USB HID v1.11 Keyboard [Logitech Logitech BT Mini-Receiver] on usb-0000:00:02.0-8.2
Sep 21 10:40:52 Magda usb 1-8.3: new full speed USB device using ohci_hcd and address 15
Sep 21 10:40:52 Magda usb 1-8.3: configuration #1 chosen from 1 choice
Sep 21 10:40:52 Magda input: Logitech Logitech BT Mini-Receiver as /class/input/input13
Sep 21 10:40:52 Magda input,hiddev3,hidraw6: USB HID v1.11 Mouse [Logitech Logitech BT Mini-Receiver] on usb-0000:00:02.0-8.3

[roberth@Magda ~]$ hcitool dev
Devices:

Any help please?

---

Use the Source, Luke!

fiatguy85

Member

Registered: 2009-01-23

Posts: 13

Re: Logitech dinovo edge stopped working

I was able to get mine listed in hcitool by using hid2hci.  Use lsusb to get the device's hex ID (just running the command hid2hci worked as well since I only had one device).  I was able to enable this behavior on start by setting HID2HCI_ENABLE and HIDD_ENABLE to true in /etc/rc.d/bluetooth and /etc/conf.d/bluetooth.

Last edited by fiatguy85 (2009-01-23 20:53:03)