You are not logged in.

#1 2009-06-08 03:16:44

trot2millah
Member
From: Oregon
Registered: 2009-06-08
Posts: 6
Website

Configuring network in VirtualBox

Hi there,

I just installed Arch Linux on a Virtualbox machine with a CD .iso file, and the install went fine.  I did not do anything to my network configuration files, because VirtualBox configures internet through an ethernet (listed as PCnet-FAST III (NAT)) cable.  I was curious if anyone has any experience configuring the internet while in VirtualBox, as I am relatively low in experience and have no idea how to go about doing this.  I followed the instructions on the wiki to add:

eth0="dhcp"
INTERFACES=(eth0)
ROUTES=(!gateway)

to my /etc/rc.conf file, but it did not help at all.

Any suggestions?  I installed Arch on a virtual machine because I anticipated problems, but if it works I'll go ahead with the full install on my test computer smile

Offline

Board footer

Powered by FluxBB