Arch Linux

JayFoxRox

Member

Registered: 2009-06-24

Posts: 2

[SOLVED] DVB-T Not working with 2.6.30

Hey, I just upgraded to 2.6.30 and my DVB-T card (TerraTec Piranha) which uses the siano driver doesn't work anymore.
It worked fine before the upgrade but doesn't register any DVB-T device since the reboot after the upgrade (Atleast kaffeine doesn't show the DVB-T button and dmesg doesn't list that a new device was registered).

After starting my computer:

[fox@PC103 ~]$ dmesg | grep sms
smsusb_probe: line: 416: rom interface 0 is not used
usb 4-2: firmware: requesting sms1xxx-stellar-dvbt-01.fw
smsusb1_load_firmware: failed to open "sms1xxx-stellar-dvbt-01.fw" mode 4, trying again with default firmware
usbcore: registered new interface driver smsusb

dmesg after reconnecting the stick:

eth0: no IPv6 routers present
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
smsusb_onresponse: line: 69: error, urb status -84, 0 bytes
usb 4-2: USB disconnect, address 3
usb 4-2: new full speed USB device using uhci_hcd and address 4
usb 4-2: configuration #1 chosen from 1 choice
smsusb_probe: line: 416: rom interface 0 is not used
usb 4-2: firmware: requesting sms1xxx-stellar-dvbt-01.fw
smsusb1_load_firmware: failed to open "sms1xxx-stellar-dvbt-01.fw" mode 4, trying again with default firmware
usb 4-2: firmware: requesting dvbt_bda_stellar_usb.inp
usb 4-2: USB disconnect, address 4
usb 4-2: new full speed USB device using uhci_hcd and address 5
usb 4-2: configuration #1 chosen from 1 choice

The file "dvbt_bda_stellar_usb.inp" exists in "/lib/firmware/" and seems to be used fine

Unluckily enough I don't know what the log looked like before the upgrade.

Whats wrong? How do I get DVB-T working again?

//Edit:

[fox@PC103 ~]$ sudo modprobe smsdvb

did the trick!
- Shouldn't this be done by default?!

PS / Not related to topic: While I'm at it, how could I fix this: "WARNING: All config files need .conf: /etc/modprobe.d/framebuffer_blacklist.pacsave, it will be ignored in a future release." - I get it about twenty times at startup since some time.

//Edit:

Fixed by removing the file and using framebuffer_blacklist.conf instead

Last edited by JayFoxRox (2009-06-24 16:12:31)