You are not logged in.
Hi, I'm trying to get pommed to run on my new MBP 13inch, but whenever I try to run the daemon it fails without any error message. Also when I run the pommed command itself I don't get any output. I tried to run with the standard mactel config and without any config.
I don't know which logs to check but dmesg doesn't show me anything.
Also I tried compiling pommed with the MacBook_Aluminum wiki tip by changing to 5,5, but still the same: no output.
Currently I'm on arch64, thanks in advance.
Last edited by jryarch (2009-07-25 19:38:49)
Offline
Hello Jryarch!
And this thread too ?
http://bbs.archlinux.org/viewtopic.php?pid=444664
What does it mean no output ? Do you get back the shell prompt without any output or it hangs on forever in an endless loop or what ?
Maybe this one is relevant too:
http://bbs.archlinux.org/viewtopic.php?id=65972
http://wiki.archlinux.org/index.php/MacBook
And maybe you can follow the aur-general thread for this matter:
http://www.archlinux.org/pipermail/aur- … 01271.html
Hope some of them help.
Offline
Thanks alot djszapi,
using the second link I got all the debug output from pommed I found out I didn't correct pommed.c the right way (ok, I was just working in the wrong dir..) and after a recompile it started fine. Now I only need to find out why I can't adjust the screen brightness in X (I can see the value change in the debug out), while it works fine from a console.
Thanks again!
[SOLVED]
Offline