You are not logged in.
Pages: 1
Well, I am trying to get my old Airlink AWLH3025 working, using the ACX111 firmware in the unstable packages.
I have it all installed, etc the only problem is it can't load the firmware.
The module tries to load till...
It says that the firmware can't be found even though if I do an "ls /lib/firmware" it shows right up.
I don't understand what could be going wrong, I used to have Arch linux a long time ago with hotplug and that worked fine, now I just can't seem to get the firmware to load.
If you could help that would be awesome
Last edited by Tree_Climber (2009-08-09 05:19:45)
Offline
Hello Tree_Climber!
Did you read these pages?
http://acx100.sourceforge.net/wiki/Firmware
http://wiki.archlinux.org/index.php/Wir … X100.2F111
Hope this helps.
Offline
Yeah I got it working all good
Offline
what were the steps you done to get this hardware working?
I have the same chipset and only got kernel panics with acx111 while following the above instructions.
Thanks
Offline
I rebooted the computer and oddly, it worked, I never had any kernel panics.
Offline
Pages: 1