USB drive won't work

soylent_green_is_hamster · 2009-01-26 19:50:53

Hi all
I can mounts USB HDs OK, but when I start copying to it, I always get the following errors:

usb 1-1: new high speed USB device using ehci_hcd and address 2
usb 1-1: configuration #1 chosen from 1 choice
Initializing USB Mass Storage driver...
scsi6 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
scsi 6:0:0:0: Direct-Access     SAMSUNG  HM160HI               PQ: 0 ANSI: 2 CCS
sd 6:0:0:0: [sdd] 312581808 512-byte hardware sectors: (160 GB/149 GiB)
sd 6:0:0:0: [sdd] Write Protect is off
sd 6:0:0:0: [sdd] Mode Sense: 34 00 00 00
sd 6:0:0:0: [sdd] Assuming drive cache: write through
sd 6:0:0:0: [sdd] 312581808 512-byte hardware sectors: (160 GB/149 GiB)
sd 6:0:0:0: [sdd] Write Protect is off
sd 6:0:0:0: [sdd] Mode Sense: 34 00 00 00
sd 6:0:0:0: [sdd] Assuming drive cache: write through
 sdd: sdd1
sd 6:0:0:0: [sdd] Attached SCSI disk
sd 6:0:0:0: Attached scsi generic sg4 type 0
usb-storage: device scan complete
usb 1-1: reset high speed USB device using ehci_hcd and address 2
usb 1-1: device descriptor read/64, error -32
usb 1-1: device descriptor read/64, error -32
usb 1-1: reset high speed USB device using ehci_hcd and address 2
usb 1-1: device descriptor read/64, error -32
usb 1-1: device descriptor read/64, error -32
usb 1-1: reset high speed USB device using ehci_hcd and address 2
usb 1-1: device descriptor read/8, error -71
usb 1-1: device descriptor read/8, error -71
usb 1-1: reset high speed USB device using ehci_hcd and address 2
usb 1-1: device descriptor read/8, error -71
usb 1-1: device descriptor read/8, error -71
usb 1-1: USB disconnect, address 2
sd 6:0:0:0: Device offlined - not ready after error recovery
sd 6:0:0:0: [sdd] Result: hostbyte=0x05 driverbyte=0x00
end_request: I/O error, dev sdd, sector 93570
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
sd 6:0:0:0: rejecting I/O to offline device
Buffer I/O error on device sdd1, logical block 32
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 33
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 34
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 35
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 36
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 37
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 38
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 39
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 40
lost page write due to I/O error on sdd1
Buffer I/O error on device sdd1, logical block 41
lost page write due to I/O error on sdd1
FAT: unable to read inode block for updating (i_pos 1223204)
FAT: FAT read failed (blocknr 49)
FAT: FAT read failed (blocknr 32)
FAT: bread failed in fat_clusters_flush
sd 6:0:0:0: [sdd] Result: hostbyte=0x01 driverbyte=0x00
end_request: I/O error, dev sdd, sector 93810
FAT: unable to read inode block for updating (i_pos 1223204)
usb 1-1: new high speed USB device using ehci_hcd and address 3
usb 1-1: device descriptor read/64, error -32
usb 1-1: device descriptor read/64, error -32
usb 1-1: new high speed USB device using ehci_hcd and address 4
usb 1-1: device descriptor read/64, error -32
usb 1-1: device descriptor read/64, error -32
usb 1-1: new high speed USB device using ehci_hcd and address 5
usb 1-1: device descriptor read/8, error -71
usb 1-1: device descriptor read/8, error -71
usb 1-1: new high speed USB device using ehci_hcd and address 6
usb 1-1: device descriptor read/8, error -71
usb 1-1: device descriptor read/8, error -71
hub 1-0:1.0: unable to enumerate USB device on port 1
usb 3-1: new full speed USB device using uhci_hcd and address 2
usb 3-1: device descriptor read/64, error -32
usb 3-1: device descriptor read/64, error -32
usb 3-1: new full speed USB device using uhci_hcd and address 3
usb 3-1: device descriptor read/64, error -32
usb 3-1: device descriptor read/64, error -32
usb 3-1: new full speed USB device using uhci_hcd and address 4
usb 3-1: device descriptor read/8, error -71

The drive is formatted FAT32, and works fine in windows. I also got this problem with another USB HD I tried, so I'm pretty sure it's not a hardware thing.

Does anyone know what those 32 and 71 error codes mean?

any help appreciated:(

soylent_green_is_hamster · 2009-01-27 20:33:03

Noone?

there's at least a few people out there with a similar problem:
http://bbs.archlinux.org/viewtopic.php?id=63126
http://ubuntuforums.org/showthread.php?t=991613

I'm currently working around it by unloading ehci_hcd, but now I'm stuck at usb1 speeds

can anyone offer any insight into this????

Cagnulein · 2009-05-03 11:26:41

same problem here...did you find any solutions?

Cagnulein · 2009-08-01 10:21:49

same problem here, any solutions?

soylent_green_is_hamster · 2009-08-01 13:08:23

turned out BOTH the usb leads on each of my hard drives were faulty!

talk about unlucky!

replaced the leads, and I now get no problems

dmz · 2009-08-18 16:51:05

Same problem here and still no solution?

lilsirecho · 2009-08-18 17:25:41

Perhaps the mobo has insufficient current to drive the USB device.

Perhaps adding a USB 2.0 card to the system will solve the difficulty.

Arch Linux

#1 2009-01-26 19:50:53

USB drive won't work

#2 2009-01-27 20:33:03

Re: USB drive won't work

#3 2009-05-03 11:26:41

Re: USB drive won't work

#4 2009-08-01 10:21:49

Re: USB drive won't work

#5 2009-08-01 13:08:23

Re: USB drive won't work

#6 2009-08-18 16:51:05

Re: USB drive won't work

#7 2009-08-18 17:25:41

Re: USB drive won't work

Board footer