You are not logged in.
Pages: 1
First, I simply created a .conf with
# Xorg -configure
When I use
X -config /etc/X11/xorg.conf
It's all black, but if I do
startx
I actually see some things.
When I exit out of both cases, I get a bunch of errors (something along the lines of error(8) and unexpected signal 2).
What could be the problem?
Also, the whole thing just crashes when I change "vesa" to "radeonhd" even though I have downloaded/installed the driver and I have a dual ATI Radeon HD 3600.
Last edited by Haptic (2009-09-04 04:21:28)
Offline
All you need to do is Xorg -configure and just move or copy the file from your home directory to /etc/X11 then it should work. Make sure you have the appropriate drivers installed before creating a .conf
Offline
Delete xorg.conf an try again. Or else, put in the xorg.conf, only these:
Section "Device"
Identifier "My Graphics Card"
Driver "radeonhd"
Option "DRI" "on"
EndSection
if you have xf86-video-radeonhd installed.
Offline
I'm not sure what I did, but when I do
X -config /etc/X11/xorg.conf
I can't get out using Alt+Ctrl+F1...
It seems to be freezing everytime I test. What would cause this? The basic X -configure freezes also.
Using VirtualBox btw
Last edited by Haptic (2009-09-05 00:29:13)
Offline
You mean you want X to start in Virtualbox'ed installation ? So enable Virtualbox additions up in the menu, mount /dev/sr0 (which now has Virtualbox additions in it) somewhere (I suppose that you don't have graphics enabled yet), run the appropriate .run file for you architecture, then try to enable xorg.conf, but I think that the .run file changes xorg.conf the proper way to make graphics work.
Last edited by flamelab (2009-09-05 00:49:41)
Offline
where's the menu that I have to type "mount /dev/cdrom0" into?
Offline
http://tombuntu.com/index.php/2008/05/2 … 804-guest/
(is a general way)
But since you are on terminal, /dev/sr0 (it represents the cdrom) is not automounted, mount it
mount /dev/sr0 on /mnt/cdrom0 (if you have created /mnt/cdrom0). There, you will see the contents of Virtualbox additions ISO. And then continue.
Advice: As I have understood, you are trying to install Arch on a VM. I think it would be better to install it on a real partition, not a VM.
Last edited by flamelab (2009-09-05 00:56:13)
Offline
Well it turns out I skipped a few drivers in the tutorial....So the freezing is fixed. I'll just stick with vesa for the virtual installation. I simply have to delete the "Device" Section with vesa and create my own with radeonhd to switch, right?
Offline
RadeonHD isn't used inside a guest OS.Only the VBox driver.
Offline
Sorry for not clarifying. I meant the actual PC, not the Virtual.
Offline
But we were talking about the VBox'ed installation all the time. The host machine, what's its problem ?
Offline
There's no problem, I was just wondering if I were to directly install arch, how I would change it.
Offline
Pages: 1