You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2009-09-04 08:28:16
- zowki
- Member
- From: Trapped in The Matrix
- Registered: 2008-11-27
- Posts: 582
- Website
eth0 and eth1 keep switching
I have a HP Compaq nc6220. I have a wifi and a lan network card. Each assigned as eth0 or eth1 but upon every boot up they keep switching interfaces! Why is that so?
How's my programming? Call 1-800-DEV-NULL
Offline
#2 2009-09-04 08:43:49
- sebcactus
- Member
- From: Germany
- Registered: 2005-01-27
- Posts: 277
Re: eth0 and eth1 keep switching
The solution is in the wiki.
Offline
#3 2009-09-04 09:00:05
- hw-tph
- Member
- Registered: 2006-11-01
- Posts: 149
Re: eth0 and eth1 keep switching
That was an awkward solution, IMHO. Why not simply load the modules in order in rc.conf (as per the wiki article referenced above) and then use /etc/iftab? Try man iftab, it is very straightforward.
Offline
#4 2009-09-04 10:08:57
- zowki
- Member
- From: Trapped in The Matrix
- Registered: 2008-11-27
- Posts: 582
- Website
Re: eth0 and eth1 keep switching
Thanks. I used the creating /etc/udev/rules.d/10-network.rules solution. I prefer that so I can set my interface to lan0 and wlan0.
How's my programming? Call 1-800-DEV-NULL
Offline
Pages: 1