Arch Linux

BlackFenix

Member

Registered: 2004-11-02

Posts: 61

How it's possible ?

I make a "ftp" arch installation and all work fine.  Arch load correct module and configure my dhcp network.  After installation, in first boot i can't connect.  This message appear before load network service:

missing kernel or user mode driver shpchp

After this network start fail.

I'm try modprobe 8139too and sis900 modules, ifconfig eht0 up..... but nothing happen.

---

[img]http://www.archlinux.org/logos/button.png[/img]
The poem is the ash of Fênix that the soul of somebody transforms into dream and transforms into body and later into light.

dtw

Forum Fellow

From: UK

Registered: 2004-08-03

Posts: 4,439

Website

Re: How it's possible ?

AFAIK shpchp is for acpi - so it should not affect your network  :!:  :?:

i get that error with hotplug too - even tho shpchp a module on the system it cannot be inserted into the kernel apparently - who knows why!

BlackFenix

Member

Registered: 2004-11-02

Posts: 61

Re: How it's possible ?

Maybe this is a problem with stock kernel.
Compile kernel can resolve it ?
I need all sugestions to configure my network. Without this, i can't install arch.

---

[img]http://www.archlinux.org/logos/button.png[/img]
The poem is the ash of Fênix that the soul of somebody transforms into dream and transforms into body and later into light.

tpowa

Developer

From: Lauingen , Germany

Registered: 2004-04-05

Posts: 2,323

Re: How it's possible ?

disable the module in hotplugs blacklist then the error will not show up again.
/etc/hotplug/blacklist
normally hotplug will identify your eth card.
if you have problems with 8139 cards also try 8139cp or 8139too module. hotplug only tries 8139cp.
8139too must be loaded by hand or in modules section in rc.conf

timmy

Member

From: Christiansfeld - Denmark

Registered: 2005-01-25

Posts: 45

Website

Re: How it's possible ?

I make a "ftp" arch installation and all work fine.  Arch load correct module and configure my dhcp network.  After installation, in first boot i can't connect.  This message appear before load network service:

missing kernel or user mode driver shpchp

After this network start fail.

I'm try modprobe 8139too and sis900 modules, ifconfig eht0 up..... but nothing happen.

What if you do: dhcpd eth0

---

Know your rights - http://rwxr-xr-x.dk

BlackFenix

Member

Registered: 2004-11-02

Posts: 61

Re: How it's possible ?

Problem solved.
My modem is configured to router but i need define eth0 with gatway, IP, broadcast, mask numbers not with "dhcp"

---

[img]http://www.archlinux.org/logos/button.png[/img]
The poem is the ash of Fênix that the soul of somebody transforms into dream and transforms into body and later into light.