You are not logged in.
- Topics: Active | Unanswered
#1 2009-10-26 02:20:40
- jeffreyldavidson
- Member
- Registered: 2008-09-05
- Posts: 47
Cups Module Will Not Load
I cannot get the CUPS module to start. It just fails. I have looked at the new CUPS issues with USB but I do not have a USB printer...it is a network printer and besides CUPS will not load at all.
Help. Thanks
Offline
#2 2009-10-26 04:00:02
- stryder
- Member
- Registered: 2009-02-28
- Posts: 500
Re: Cups Module Will Not Load
I just upgraded and it worked fine here. Did you use the new cupsd.conf (based on /etc/cups/cupsd.conf.default) as instructed? For me, I just replaced my old cupsd.conf with cupsd.conf.pacnew.
Offline
#3 2009-10-26 17:10:12
- jeffreyldavidson
- Member
- Registered: 2008-09-05
- Posts: 47
Re: Cups Module Will Not Load
Yes, I tried that as well. I went through all the USB trouble steps, but the module just will not start. I have it in my rc.conf daemons but even if I try to manually restart I just get the message that it fails.
Stumped.
Offline