You are not logged in.
Pages: 1
I purchased the Anyware/Mediagate GP-IR02BK USB MCE remote / reveiver after reading on several sites that it works just fine in linux.
I have never used LIRC before so I went to the wiki and followed the instructions step by step.
I installed both lirc and lirc-utils
I then ran: "setserial /dev/ttyS0 uart none" followed by "modprobe lirc_mceusb2" (both as root)
Then I ran: "lircd" as root and got this:
lircd: WARNING: you should specify a valid gap value
I continued and ran irw both as a normal user and as root, but when I mashed buttons on my remote there is no terminal output. That being said I believe the remote / receiver are talking to each other because whenever I push a button on the remote a light blinks on the receiver.
I decided to check to make sure Arch saw the receiver. I ran lsusb and got this:
Bus 003 Device 002: ID 1784:0008 TopSeed Technology Corp.
This entry did not appear when I unplugged the receiver and ran the same command so I concluded this was my receiver.
Any ideas or suggestions would be great.
Last edited by Dethredic (2009-11-07 04:02:45)
Offline
Using lirc 0.8.6 setting up an MCE remote ought to be as easy as:
$ sudo cp /usr/share/lirc/remotes/mceusb/lircd.conf.mceusb /etc/lirc/lircd.conf
$ sudo modprobe lirc_mceusb
(NB. lirc_mceusb2 is no more)
$ sudo /etc/rc.d/lircd start
$ irw
Press a few keys on the remote.
Offline
Offline
Pages: 1