You are not logged in.
Hey all,
I recently started having trouble with HAL automounting my external. I just did a pac -Syu today, and it stopped working. I get this error message when I plug it in:
Rejected send message, 1 matched rules; type="method_call", sender=":1.86" (uid=1000 pid=7449 comm="exo-mount) interface="org.freedesktop.Hal.Device.Volume" member="Mount" error name="(unset)" requested_reply=0 destination="org.freedesktop.Hal" (uid=0 pid=7389 comm="/usr/sbin/hald)).
Dmesg returns this output:
usb 1-1: new high speed USB device using ehci_hcd and address 8
usb 1-1: configuration #2 chosen from 1 choice
scsi7 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 8
usb-storage: waiting for device to settle before scanning
scsi 7:0:0:0: Direct-Access TOSHIBA MK8025GAS KA02 PQ: 0 ANSI: 0 CCS
sd 7:0:0:0: Attached scsi generic sg1 type 0
usb-storage: device scan complete
sd 7:0:0:0: [sdb] 156301488 512-byte logical blocks: (80.0 GB/74.5 GiB)
sd 7:0:0:0: [sdb] Write Protect is off
sd 7:0:0:0: [sdb] Mode Sense: 00 4a 00 00
sd 7:0:0:0: [sdb] Assuming drive cache: write through
sd 7:0:0:0: [sdb] Assuming drive cache: write through
sdb: sdb1
sd 7:0:0:0: [sdb] Assuming drive cache: write through
sd 7:0:0:0: [sdb] Attached SCSI disk
Any suggestions?
Last edited by semperfiguy (2009-11-20 02:25:49)
Offline
Offline
*smacks head* I apologize. I was lazy.
Offline