You are not logged in.
Pages: 1
I've installed Arch .7 and have updated the system with pacman. I set up the system to use udev.
I have an Adaptec AHA-7850 scsi card with a Sony SDT-9000 tape drive attached as the only scsi device.
When I check out /dev, there is an sg0 device, but no tape, st0, nst0, etc. dmesg shows the tape drive identified at boot, and cat /proc/scsi/scsi also shows it.
I can't use mt on the sg0 device, and I'm not sure if that is my controller or my tape drive, and if the tape drive, how I gain access to it.
Thanks in advance.
Offline
Ok, I figured it out. I was using kernel26-scsi, but didn't realize I still needed to load the scsi tape module (st) into rc.conf. Did that, now it works.
Offline
Pages: 1