Arch Linux

digidrops

Member

Registered: 2007-10-06

Posts: 2

dvb Card: Artec T1 USB1.1 TVBOX with AN2235 after Kernel upgrade

Many years I used this card with many different kernel versions. And now after upgrade to 2.6.31 it won't tune in.
She downloads the firmware correctly, which also worked many years without a change. dmesg messages are:

usb 2-1: new full speed USB device using ohci_hcd and address 9
usb 2-1: configuration #1 chosen from 1 choice
dvb-usb: found a 'Artec T1 USB1.1 TVBOX with AN2235 (faulty USB IDs)' in cold state, will try to load a firmware
usb 2-1: firmware: requesting dvb-usb-dibusb-an2235-01.fw
dvb-usb: downloading firmware from file 'dvb-usb-dibusb-an2235-01.fw'
usb 2-1: USB disconnect, address 9
dvb-usb: generic DVB-USB module successfully deinitialized and disconnected.
usb 2-1: new full speed USB device using ohci_hcd and address 10
usb 2-1: configuration #1 chosen from 1 choice
dvb-usb: found a 'DiBcom USB1.1 DVB-T reference design (MOD3000)' in warm state.
dvb-usb: will use the device's hardware PID filter (table count: 16).
DVB: registering new adapter (DiBcom USB1.1 DVB-T reference design (MOD3000))
DVB: registering adapter 0 frontend 0 (DiBcom 3000M-B DVB-T)...
dibusb: This device has the Thomson Cable onboard. Which is default.
input: IR-receiver inside an USB DVB receiver as /devices/pci0000:00/0000:00:0b.0/usb2/2-1/input/input11
dvb-usb: schedule remote query interval to 150 msecs.
dvb-usb: DiBcom USB1.1 DVB-T reference design (MOD3000) successfully initialized and connected.

for me it looks good.

I also have all the

ls /dev/dvb/adapter0/
demux0     dvr0       frontend0  net0

But the famous mplayer:

Playing dvb://ZDF.
dvb_tune Freq: 570000000
Not able to lock to the signal on the given frequency, timeout: 30
dvb_tune, TUNING FAILED
ERROR, COULDN'T SET CHANNEL  23: Failed to open dvb://ZDF.


Exiting... (End of file)