You are not logged in.
Hello,
I'm using Arch on a T61P with a nVidia Quadro FX 570M.
My video card is correctly installed and working good using the nvidia driver (as you can see on the logs at the bottom). dpi are set correctly and resolution too ... but all my fonts, buttons, ... are way too big on software like firefox, terminator, k3b, ... as if the resolution wasn't set right ... but those are ok on other like tint2 or xterm.
I don't know how to resolve this issue and get a "good" small and nice resolution on those apps ....
Need help ...
here are some logs about my config... =>
uname -r
2.6.31-ARCH
lspci | grep VGA :
01:00.0 VGA compatible controller: nVidia Corporation Quadro FX 570M (rev a1)
glxinfo | grep direct :
direct rendering: Yes
xdpyinfo | grep resolution :
resolution: 147x145 dots per inch
xrdb -q | grep dpi :
Xft.dpi: 146.0166015625
xrandr --current :
Screen 0: minimum 320 x 175, current 1920 x 1200, maximum 1920 x 1200
default connected 1920x1200+0+0 0mm x 0mm
1920x1200 50.0* 51.0 52.0
1600x1200 53.0
...
xdpyinfo | grep dimensions :
dimensions: 1920x1200 pixels (332x210 millimeters)
Xorg Device section :
Section "Device"
Identifier "Card0"
Driver "nvidia"
VendorName "nVidia Corporation"
BoardName "Quadro FX 570M"
EndSection
Last edited by xux (2009-12-21 11:09:10)
Offline
dpi are set correctly
Xft.dpi: 146.0166015625
Try 120 for that number. Background info.
Offline
Thanks for the answer, i actually set it at 96 in Xorg.conf :
Section "Monitor"
Identifier "Monitor0"
VendorName "Unknown"
ModelName "Unknown"
HorizSync 28.0 - 33.0
VertRefresh 43.0 - 72.0
Option "DPMS"
Option "DPI" "96 x 96"
EndSection
and it worked !!!
Thanks a lot
Offline