You are not logged in.

#1 2010-02-27 06:50:27

Xenokite
Member
From: Linden, NJ USA
Registered: 2009-03-14
Posts: 96
Website

A funny error!

I was trying to install arch on a older pc for fun to try out packages or whatever and after getting all base install sometime during the bootup and mainly when it is idle i get this crap.

UHHUH, NMI RECEIVED FOR UNKNOWN REASON 2D/3D ON CPU 0
DO YOU HAVE A STRANGE POWER SAVING MODE ENABLED?
DAZE AND CONFUSED, BUT TRYING TO CONTINUE

Now I would get this message echoed back to me a good 200 to 300 time if i leave it idle in the console before i boot into the Xorg or xserver (GUI) then after that when i do try to load xserver i get this error.

 Backtrace:
0 : x (xorg_backtrace+0x3b) [0x809b93b]
1 : x (0x8048000+0x5cc55) [0x80a4c55]
2 : (vdso) (__kernel_rt_sigreturn+0x0) [0xb774840c]
Segmentation fault at address 0xc
Fatal Server error: caught signal "(segmentation fault).
server aborting

Now i love too know what the hell is doing this and fix this problem, on a side note even when i install window it give me an error also but i never wrote it down (don't care much for the doze) lol


Let me add i do know it is not the HD's cause i swaped out a few and they all did the same thing.

Last edited by Xenokite (2010-02-27 06:53:14)


Registered Linux user :#500622
"être fort pour être utile" (be strong to be useful) —Georges Hébert
"There is only Good people and Bad people, we should not be judged by Race, religion or sex but we should be judged by our deeds or actions." - Lindsey Irving
Xenokite aka Lycan

Offline

Board footer

Powered by FluxBB