You are not logged in.
Pages: 1
Hi,
I installed open-vm-tools in my Arch x64 installation in VMWare Fusion, added it to rc.conf, but it resists to start properly and gives me a [FAIL] instead
[industrie13@arch64 ~]$ sudo /etc/rc.d/open-vm-tools start
:: Starting Open Virtual Machine Tools [FAIL]
[industrie13@arch64 ~]$ sudo /etc/rc.d/open-vm-tools restart
:: Stopping Open Virtual Machine Tools [BUSY]
ERROR: Module vmhgfs is in use
[FAIL]
:: Starting Open Virtual Machine Tools [FAIL]
Any hints? A re-install didn't help.
Offline
what kernel version do you use ?
Give what you have. To someone, it may be better than you dare to think.
Offline
This happens to me to sicne I first installed Arch (kernel 2.6.34-1). I gave up on it since I seem to have shared folders regardless.
Meanhwile, In X the new open-vm-tools version seems to have problems dealing with mouse integration. It works intermittently, when before it used to work great. But clipboard sharing works great.
Kernel: 2.6.34-2
Last edited by marfig (2010-08-08 18:18:43)
I probably made this post longer than it should only because I lack the time to make it shorter.
- Paraphrased from Blaise Pascal
Offline
what kernel version do you use ?
[industrie13@arch64 ~]$ uname -r
2.6.34-ARCH
and x64
Last edited by industrie13 (2010-08-08 18:42:13)
Offline
Ok, at system boot open-vm-tools start in the background without [Fail]-message, even when I didn't marked it as such in rc.conf.
The message when I do a "sudo /etc/rc.d/open-vm-tools restart" keeps the same. How can I verify that vmware-tools are started properly?
Offline
Pages: 1